Contractor Grade Category 6 Shielded SPEEDY RJ45 Plug
Our plugs are designed to simplify twisted pair terminations by allowing the wire pairs to be easily inserted through the plug and out of the front. This allows the installer to easily check the wiring order before crimping the connector. Twist is maintained more easily enabling a better performing crimp. Waste is minimised and the plugs are suitable for either stranded or solid wires.
Click here for drawing
Allows Category 6 twisted pair wires to be inserted through the body and pulled out of the front to ensure the correct wiring order before crimping
By pulling the cores into the plug, twists can easily be maintained up to the contacts, enabling fully rated category performance
Contact blades are suitable for stranded or solid wire cores from 22‐26 AWG (0.65 – 0.40mm), with insulation up to 0.98 ± 0.04mm O.D
Perfect solution for rapid termination
Suitable for termination of solid or stranded STP cables with sheath O.D. of 5.0 – 6.5mm
Faults and failures minimised
Simple one piece design
Shielded cable can be easily terminated without need for soldering
Foil wrap included to improve performance of shielding
N.B. Must be used with suitable crimp tool i.e TRCSPDY3
Designed for use with polycarbonate flush strain relief boots (PSPDY6) and coloured PVC flush strain relief boots (PS6)
Housing: Polycarbonate UL94‐V0
Contact pin: 50”µ/1.27 µm gold plating over nickel over phosphor bronze
Shell: Phosphor bronze
Foil wrap: Aluminium
Contact resistance: 30milliΩ max.
Insulation resistance: DC 300V, 100 MegaΩ min.
Dielectric withstanding voltage: 300V AC for one minute
Working temperature: ‐25‐55˚C
Durability: 1000 mating cycles min.
Tensile strength between plug and jack is higher than 7.7kg
Supplied in polybags of 10, then 100, then 500. Also available with reduced packaging as bags of 200
200: PXSPDY6Sb#200 (Supplied loose in bag)
EAN number: 5055386506900